Experimental analysis of tubular wall-threaded sections submitted to ultra-low cycling fatigue

Authors

DOI:

https://doi.org/10.13140/RG.2.2.33587.73767

Keywords:

fatigue of ultra-low cycling, tubular steel elements, failure due to local buckling

Abstract

The present work of investigation studies the behavior of steel structural sections of thin wall, made in Venezuelan Conduven ECO, of square cross section, constructed in the form of a cantilever type beam, under the effects of fatigue of ultra-low cycling. Experimental tests were carried out applying histories of cyclic displacements, with low speed and acting in a range that goes from the yielding effort to the last effort of the element, obtaining a degradation of the resistant capacity of the elements through the phenomenon of fatigue of ultra-low Cycling, induced by the appearance of the fault by local buckling in the elements tested.

Author Biographies

  • Leonardo López, Universidad Centroccidental Lisandro Alvarado. Venezuela
    Teaching Researcher at the Universidad Centroccidental Lisandro Alvarado. Venezuela. Civil engineer. Email: leonardo.lopez@ucla.edu.ve
  • María Eugenia Marante, Universidad Centroccidental Lisandro Alvarado. Venezuela
    Dr. in Structural Ingeneiría. Teaching Researcher at the Universidad Centroccidental Lisandro Alvarado. Venezuela. Civil engineer. Email: emarante@ucla.edu.ve
  • Ricardo Picón, Universidad Católica de Temuco. Chile
    Teaching researcher at the Universidad Católica de Temuco. Department of Civil Engineering of Civil and Geological Works. Temuco Chile. Civil engineer. Email: rpicon@uct.cl

References

S. Oller, FRACTURA MECANICA UN ENFOQUE GLOBAL, Barcelona, España, Centro Internacional de Métodos Numéricos en Ingeniería, 2001

J. Arana y L. Gonzalez, Mecánica de Fractura, Bilbao, España: Servicio Editorial, 2008

A. Loureiro, Ensayos de Estruturas Offshore y Otras Estructuras Singulares. Ingenieria de Puertos y Costas. CEDEX., Madrid, España, 2000

G. Maciel, The WindFloat Project, EDP. Inovacao, 2010

D. Fernandez de Rucoba, Optimización del Diseño a Fatiga de Uniones Soldadas a Tope y su Aplicación al Dimensionamiento de Soldaduras Transversales de Torres Eólicas, Santander, España, 2012

L. Calderón, Propuesta de Optimización Estructural de Torre Eólica Metálica Sometida a cargas Estáticas, Catalunya, España, 2012

J. C. R. Pereira, J. Van Wittenberghe, A. Jesus, P. Thibaux y A. A. Fernandes, ULTRA LOW CYCLE FATIGUE BEHAVIOR OF FULL-SCALE STRAIGHT PIPES UNDER ALTERNATING BENDING, Vancouver, British Columbia, Canada: Proceedings of the ASME 2016 Pressure Vessels and Piping Conference, 2016

L. Lopez, Análisis Numérico-Experimental de Estructuras de Acero con Perfiles Tubulares de Pared Delgada Sometidos a Fatiga de Ultra-Bajo Ciclaje, Universidad Centroccidental Lisandro Alvarado, Lara, Venezuela, 2017

R. Febres, P. Inglessis y J. Flórez-López Modeling of local buckling in tubular steel frames subjected to cyclic loading. Computers and Structures 81 (2003) 2237-2247, 2003

H. R. Amiria, A. Aghakouchaka, S. Shahbeyka y M.D. Engelhardt, Finite element simulation of ultra-low cycle fatigue cracking in steel structures, Faculty of Civil and Enviromental Engineering, Teheran, Tarbiat Modares University, Journal of Constructional Steel Research 89 175-184, Elseveir, 2013

Leonardo López, María Eugenia Marante, Ricardo Picón

Downloads

Published

2017-12-06

Issue

Section

Research articles

How to Cite

Experimental analysis of tubular wall-threaded sections submitted to ultra-low cycling fatigue. (2017). Gaceta Técnica, 18(1), 23-34. https://doi.org/10.13140/RG.2.2.33587.73767